Injection-moulding machine (rubber)

clamping force 11000 kN︱injection volume 12500 cm³︱screw diameter -- mm︱platen size 1000 x 1800 mm︱

---

Condition: used, Specification: injection moulding machine for rubber - used, in very good condition machine was serviced annually by manufacturer clamping unit: - Euromap (size): 11000-25600 - clamping force: 11.000 kN - size of heating platens L/W/H: 1000 x 1800 x mm - Distance upper- lower plate: 1200 mm - Stroke min.: 630 mm - Max. stroke: 1030 mm Injection unit: - Injection volume max.: 12,500 cm³ - Injection pressure: 2050 bar - Dosing force: 118 kN - Control: Siemens S7 - Connected load: 3x 400 V, 50 Hz, N - Total current: 276 A - Back-up fuse: 300 A - Pump drive: 277 bar - Driving power: 45 kW - Weight approx.: 43.8 t Operating hours approx.: 33,130 hours

clamping force 2700 kN︱injection volume 3300 cm³︱screw diameter -- mm︱platen size 780 x 670 mm︱

---

Condition: used, Specification: vertical injection moulding machine for rubber NR, EPDM, SBR, NBR, CR, etc. - used, in very good condition 6 months in use clamping unit: - Euromap (size): 2700-7200 - Clamping force: 2,700 kN - Heating platen size L/W/H: 780 x 670 mm - Distance between upper and lower platen: 970 mm - Stroke min.: 420 mm - Stroke: 550 mm Injection unit: - Injection volume max.: 3,300 cm³ - Injection pressure: 2,180 bar - Nozzle contact force: 80 kN - Connected load: 3x 400 V, 50 Hz, N - Back-up fuse: 125 A - Pump drive: 265 bar - Drive power: 22 kW - Pump speed: 66 rpm - Current: 41 A - Weight approx.: 11.2 tonnes Operating hours approx.: 8,185 hours